Sunday, December 2, 2012

9ft 6" Pintail Slider

 Hot wired EPS blank with 5mm Paulownia stringer ready to be cut
 Blank cut on AKU cnc machine , this time rails squared and top and bottom cut all at once to save time. Normally get the rails cut square and than laminate the outline with 4mm Paulownia prior to getting the deck and bottom cut.
 4mm Paulownia laminated on and foiled to the board shape.
 Glued and bagged on the rocker table to hold the rocker and avoid any twist.

 Out of the bag after 2 1/2 hours

Deep concave through to a nice roll out the tail , sweet shape.

No comments:

Post a Comment